pH/EC/TDS Temperature Meter

These meters feature a large LCD which displays either pH, EC, TDS or temperature readings along with tutorial instructions. The pH readings are displayed with a 0.1 resolution and an accuracy of ±0.1 pH while the EC and TDS readings are displayed with a 10 m/s/cm and 10 ppm (mg/L) resolution and 2% full scale accuracy. Please select the meter with the range you require for your testing.

The temperature correction coefficient (β) is fixed at 2%/°C and allows for automatic temperature compensated measurements of EC and TDS. These meters are calibrated manually to a single point with the use of two trimmers. pH is calibrated to pH 7.01 while EC/TDS is calibrated to either 1.41 mS/cm (1413 µS/cm) or 1500ppm. The LCD screen has battery life indicator as well as on-screen tutorial messages.

No probe changes are required when switching your measured parameter between pH, conductivity and TDS. These multiparameter meters reduced the number of instruments required for daily water quality analysis.

The supplied probe on all models feature a polypropylene body, amplified pH electrode with a built-in EC/TDS and temperature sensors. The amplifier for the pH electrode prevents interference from humidity and electrical noise from common sources including the motors, ballasts or pumps.

 

HI-1285-51 probe

The HI-9811-51 and HI-9812-51 are supplied with the HI-1285-51 pH/EC/TDS/temperature probe. The pH, EC, TDS, and temperature sensor are housed in a single body that connects to the meter with a DIN connector.

 

Amplified pH electrode

The pH electrode circuit has a built in amplifier that will reduce the effects of electrical noise on the high impedance pH measurement. Examples of sources of electrical noise include motors, ballasts, and pumps which are common in greenhouses.

 

Amperometric EC/TDS sensor

The EC/TDS readings are performed by an amperometric sensor. An alternating voltage is applied to the sensor and the amount of current that passes between the two stainless steel pins is dependent upon the amount of salts (fertiliser) present. A greater amount of salt present results in an increase in conductance.

 

Polypropylene body

The polypropylene body houses all the sensors in a single body design and is durable. The probe is gel filled for maintenance free operation. It does not have to be refilled periodically.

3 sensors in a single probe

Gel filled maintenance free pH electrode

Range
EC		-				0 to 1990 µS/cm
TDS		-				0 to 1990 ppm (mg/L)
pH		-				0.0 to 14.0 pH
Temperature		-				0 to 60°C
Resolution
pH		-				0.1 pH
EC		-				10 µs/cm
TDS		-				10 ppm (mg/L)
Accuracy
pH		-				±0.1 pH
EC		-				±2% F.S.
TDS		-				±2% F.S.
Temperature		-				±1°C
TDS Conversion Factor		-				0.5 ppm (mg/L) = 1 µS/cm
pH Calibration		-				manual, 1 point through offset trimmer
EC/TDS Calibration		-				manual, 1 point through slope trimmer
EC/TDS Temperature Compensation		-				automatic from 0 to 70°C with β = 2% /°C
Probe		-				HI 1285-51 pH/EC/TDS/Temperature, polypropylene body, pre-amplified multiparameter probe with internal temperature sensor, 8-pin DIN connector and 1m cable included
Battery Type / Life		-				9V / approximately 450 hours of continuous use
Environment		-				0 to 50°C; RH 100%
Dimensions		-				145 x 80 x 36mm
Weight		-				230g